www.roksan.co.uk

sd · Joined: 09 Nov 2011 Posts: 2

Hi

I have joined the roksan website as I was advised to do so by yourself. I was recently on the naim website. I have had a TMS for the last 14 years and yesterday I happened to remove the plate with long spindle, cleaning the 'bearing" and added about 5 drops of roksan oil. But what I notice is the top platter rests completely on the top plinth. Ususally there is a 2mm gap between the top plinth and the top platter. It does not want to fit on the smaller platter.

Any advise on that.

SD

davie1967 · Joined: 27 Jul 2006 Posts: 427 Location: Glasgow,Scotland

i think it is possible you have removed the Ball Bearing that supports the spindle. there are specific instructions on how to do the cleaning/re-oiling procedure on the Roksan website. if you used a Q-tip/cotton bud it might be stuck to that. if the ball is there i do not know enough about the TMS to advise. maybe someone else will be along to help
Confused

_________________
1987 Xerxes, XPS3. modded Rb250, Ortofon Samba MC..Rotel.RC06 pre .+ 2 RB06 bridged, Royd RR1's

Polarbear · Joined: 07 Mar 2005 Posts: 2351

Welcome to the Roksan forum SD.

How's that TMS coming along, I know you have found the ball bearing from the Naim forum, is the deck starting to settle down now?

Regards

PB

sd · Joined: 09 Nov 2011 Posts: 2

found the ball bearing on the carpet. Its working just fine and better still after I added the bearing oil.
Thanks
SD

davie1967 · Joined: 27 Jul 2006 Posts: 427 Location: Glasgow,Scotland

. nice to hear that.
_________________
1987 Xerxes, XPS3. modded Rb250, Ortofon Samba MC..Rotel.RC06 pre .+ 2 RB06 bridged, Royd RR1's